things you will need!
•rent a concrete sander
•pads for sander
• paint thinner
•hammer
• small crow bar
• a box cutter
•latex concrete paint
• and your choice of glaze
•polyurethane for the top coat
Step one: remove old car pet and the tack board strips with nails
(hammer,crow bar, box cutter)
Step two:place pad on sander , throw down some corn mill and begin sanding your area.
Step three: if you still have some glue residue that's where the good old paint thinner comes in!
(rag, brush, paint thinner!) ---you must get the glue residue off!
Step four:sweep and vacuum your area for the last time to make sure your area is clean.
Step five: with a roller and a long stick roll your choice color of latex concrete paint on, this might take two coats depending on condition of concrete


Scary bright huh? This is a rust color.
Step six: let area dry
Step seven: the choice we needed involved 4 extra colors

Brown, maroon, yellow, red.
You swirl brush the brown on bottom.
You take the remaining three colors and begin
Red and Maroon very heavy on top of of brown.
Then yellow on top to mix it all in


Now that we have seen that we go to this next step

Same are just blended
And we are FINISHED

•last but not least you add two colors of the polyurethane.
Taaadaaa
until next time...Miss Whit
0 comments:
Post a Comment